powder coated valence help

jb.hatch Posted 2012-01-27 7:41 AM (#106222) Subject: powder coated valence help Cruiser Posts: 249 Phenix City AL. I had my winshield valence powder coated, but they melted off all the mounting tabs, what is the best way to re attach the mounting points? CoolHandLuke Posted 2012-01-27 11:47 AM (#106235 - in reply to #106222) Subject: Re: powder coated valence help Iron Butt Posts: 849 , FL United States Same thing happened when I did mine and I think we used JB WELD to re-attach them. Hope this helps. johnnyvision Posted 2012-01-27 11:53 AM (#106236 - in reply to #106222) Subject: Re: powder coated valence help Visionary Posts: 4278 Post a photo. You mean the four bullets that go into the rubbers? If its the four bullets you could use bolts now. Sand the two surfaces real good use JB weld and put a little grease on your rubber grommets. CoolHandLuke Posted 2012-01-28 8:29 PM (#106309 - in reply to #106236) Subject: Re: powder coated valence help Iron Butt Posts: 849 , FL United States yeah John, that's what we're talking about. JB Weld seemed to do the trick on mine.