|
|
Cruiser
Posts: 104
| Hi guys
My left heated grip is rotating about 1/8" on the handle bar and driving me nuts. Just feels loose. Is there a way to tighten that up some how or that how they all are??
Thanks |
|
| |
|
Iron Butt
Posts: 612
| hawaii - 2012-02-09 8:10 PM
Hi guys
My left heated grip is rotating about 1/8" on the handle bar and driving me nuts. Just feels loose. Is there a way to tighten that up some how or that how they all are??
Thanks
There are two torx head screws that secure it to the bar. One or both is probably backed out. You have to roll back the rubber grip flange a little to get to the screws.
|
|
| |
|
Cruiser
Posts: 104
| Hey thanks Turk! Which end should I roll back? Or both ends? Should I take off the end cap first? |
|
| |
|
Puddle Jumper
Posts: 24
Alberta | The flange to roll back is next to your thumb side, somewhere around the 11 o'clock and 5 o'clock postiion when looking from the bar end weight
Edited by Bad Horsie 2012-02-10 11:46 AM
|
|
| |
|
Cruiser
Posts: 160
Camas Washington | Mine just started doing this. Will check to make sure it is screwed down tight. |
|
| |
|
Iron Butt
Posts: 612
| hawaii - 2012-02-10 11:14 AM
Hey thanks Turk! Which end should I roll back? Or both ends? Should I take off the end cap first?
The end nearest the clutch perch.
And, each of those 2 torx screws has a hole that it goes into, it doesn't just press against the outside of the bar.... so make sure it's properly lined up....
Edited by Turk 2012-02-10 1:23 PM
|
|
| |
|
Cruiser
Posts: 104
| Just wanted to thank Turk for the great advice! It was right on. No more wiggle in the grip.
Thanks again Turk!
|
|
| |
Left Heat grip rotating a bit