|
|
Cruiser
Posts: 258
Akron, Ohio | In the factory tool kit for the Vision, (don't know if the other Victories come with the same kit), there is a 4mm x 6mm wrench. What is this for? To me it looks like a spoke wrench. I am just going through my tool kit and realized I have no clue what it fits on the bike. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | a lot of things. your dash screws, seat screws and various other screws under the cowl panel for mirrors, etc. Also the 10mm open end wrench comes in handy. |
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | varyder - 2012-03-04 8:55 AM
a lot of things. your dash screws, seat screws and various other screws under the cowl panel for mirrors, etc. Also the 10mm open end wrench comes in handy.
+1
|
|
| |
|
Cruiser
Posts: 258
Akron, Ohio | I understand the allen wrenches, but this is an open-end. Just making sure I explained it right. |
|
| |
|
Visionary
Posts: 3006
San Antonio, TX | They are not for any specific reason that I know. I use them to work on the Vision and to remove the seat. I was thinking of making up a small tool set to carry with me that would include four sizes of T-Handle ball-end allen wrenches and other common tools. I have just been too lazy to do it.
Ride Safe |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | okay - I may not have that one, or I took it out and replaced it with a Craftsman. I have a small arsenal of tools that fit in a small bag. |
|
| |
|
Cruiser
Posts: 83
Bolivar Missouri | My guess is that the end wrenches are there for tightening throttle cables and other small items that occasionally work loose |
|
| |
Factory tool kit wrench??