|
|
New user
Posts: 1
| I have 2007 Hammer with 92k miles. I install a Barnett Scorpion clutch. The clutch slipped from the start. The stack height was correct. I was use victory oil. Upon disassembly I noticed that the throwout bearing release rack did not rotate freely. Pulling the pressure plate there was signs that the release rack was bottoming on the transmission input shaft. I contacted Barnett they said they had never heard of that and would look onto it. I machined down the input shaft and reassembled the clutch. So far so good. |
|
| |
|
Visionary
Posts: 2300
Georgia, west of Atlanta | Interesting: Pleases keep us informed if you have time. I have a Barnett Scorpion clutch on my 116 HP Sportster and it's a weak tranny four speed. Never had a problem there. It's always good to keep up with any current problems if it's a one time thing or a design flaw............... |
|
| |
|
Iron Butt
Posts: 810
| I went through 3 scorpion clutches in a few thousand miles on my 2008 Vision. The first one lasted about 200 miles. I went back to the factory clutch. Didn't want to get bit by the scorpion a 4th time.
|
|
| |
Barnett Scorpion Clutch Problem