exhaust leak
new vic rider
Posted 2014-05-31 12:12 AM (#157847)
Subject: exhaust leak


Cruiser

Posts: 53
Shelbyville, IL United States
Changed mufflers on my Vision monday. Now I have a leak where the rear header crossover pipe connects to to the front header pipe. I loosened it up per the service manual when taking off mufflers. I have tightened the heck out of it and it will not seal. Any ideas ? Am I going to have to take the muflers back off and readjust it to get it to quit leaking ?
Top of the page Bottom of the page
ByteN2it
Posted 2014-05-31 4:57 AM (#157849 - in reply to #157847)
Subject: Re: exhaust leak


Tourer

Posts: 482
Beer Collins, Colorado (there is no fort)
This is what I used when I installed my Vision's S1L2 slip ons. Just run a bead around the pipe during assembly and it help everything slid together and then seal when cured.
http://www.all-spec.com/products/81878.html?gclid=CLuAsYLy1b4CFcQ7M...
Top of the page Bottom of the page
johnnyvision
Posted 2014-05-31 5:45 PM (#157864 - in reply to #157847)
Subject: Re: exhaust leak


Visionary

Posts: 4278
If it does not seal and the clap is as tight as you can get it.

Pull it a part and with a hacksaw put some crosshatch cuts in pipe put back togethere and re tighten you should be good
Top of the page Bottom of the page