|
|
Iron Butt
Posts: 691
Manchester, CT | does anyone know how to reboot the ECM on a Visio? |
|
| |
|
Iron Butt
Posts: 935
Rockford, IL | I'm pretty sure I remember reading somewhere here that you simply unplug the ECM for a few minutes. But I'll admit that I'm not positive on this..... |
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | i cant speak for the vision. but i know on my honda (car) when you want to erase a error code or reset the computer so that it can "relearn" , all you do it disconnect the battery for 5-10 mins then reconnect... i did this recently when i was having low idle issues.. it allowed the ecu to relearn and all has been well.. (speaking about my car not scooter) my point is. there was nothing special outside of disconnection the battery. |
|
| |
|
Iron Butt
Posts: 691
Manchester, CT | thanks guys..I'll give it a shot. the only thing is if the configs and error logs are stored on an EPROM, disconnecting power won't clear it. |
|
| |
|
Visionary
Posts: 4278
| go to dealer. Battery disconect will do nothing. Un pluging ECM will do nothing Go to Dealer |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | I thought you disconnected, unbolt it, and then turn it upside down and shake it like an etch-a-sketch, then reinstall... |
|
| |
|
Cruiser
Posts: 123
NE Florida Jacksonville | Gee when I shook mine it only makes vertical lines. Darn!
|
|
| |
vision reboot/reset ECM