Removing rubber floorboard insert
Stryker
Posted 2008-09-01 8:12 PM (#17368)
Subject: Removing rubber floorboard insert


Puddle Jumper

Posts: 41
Oviedo, FL		I was attempting to install my highway pegs but the instructions were unclear to me as to how to remove the rubber floorboard insert to access the bolts to attach the pegs. I have the chrome floorboards.
Top of the page Bottom of the page
racershawn
Posted 2008-09-01 8:15 PM (#17369 - in reply to #17368)
Subject: Re: Removing rubber floorboard insert


Cruiser

Posts: 231
Hampton Va		They just pull up...I just did it
Top of the page Bottom of the page
Stryker
Posted 2008-09-01 8:21 PM (#17370 - in reply to #17368)
Subject: Re: Removing rubber floorboard insert


Puddle Jumper

Posts: 41
Oviedo, FL		Thanks, I'll try that I just hate forcing anything.
Top of the page Bottom of the page
Code Blue
Posted 2008-09-01 11:51 PM (#17387 - in reply to #17368)
Subject: RE: Removing rubber floorboard insert


Puddle Jumper

Posts: 22
Don't just pull them, that could tear the insets, instead while your pulling try pinching the rubber insets from the bottom, that will cause them to pop out safely.
Top of the page Bottom of the page
mkultra
Posted 2008-09-02 9:40 AM (#17399 - in reply to #17368)
Subject: Re: Removing rubber floorboard insert


Tourer

Posts: 374
Tucson, AZ		Use a little soapy water and then squeeze from below as you push the tabs through.

mike v
Top of the page Bottom of the page