Exhaust header pipe
witchbiker
Posted 2016-07-17 6:53 AM (#186552)
Subject: Exhaust header pipe


Cruiser

Posts: 222
Barefoot Bay, FL United States

Where would I find the exhaust header dimensions (OD, ID) listed for the Vision? I can find the parts listing, but no sizes. 2.125", 2.25", 2.5"??


2008 Vision Tour

Chrome IS a color

Top of the page Bottom of the page
johnnyvision
Posted 2016-07-18 5:28 PM (#186561 - in reply to #186552)
Subject: Re: Exhaust header pipe


Visionary

Posts: 4278
can't you measure yours. Would think the cross country would have the same size pipe along with maybe the steel frame bikes
Top of the page Bottom of the page
Chico7z
Posted 2016-07-19 7:47 AM (#186564 - in reply to #186552)
Subject: Re: Exhaust header pipe


Cruiser

Posts: 170
Barrington, NH
I have one at the shop if you want to swing by an take some measurements. It's already off the bike...
Top of the page Bottom of the page
Arkainzeye
Posted 2016-07-19 3:25 PM (#186582 - in reply to #186552)
Subject: Re: Exhaust header pipe


Visionary

Posts: 3773
Pittsburgh, PA
My guess and I could be completely wrong. The reason why you don't find sizes for the parts is because it only comes in one size therefore it's unnecessary to mention what size it is because you don't have a choice.
Top of the page Bottom of the page
witchbiker
Posted 2016-08-01 2:51 PM (#187940 - in reply to #186564)
Subject: Re: Exhaust header pipe


Cruiser

Posts: 222
Barefoot Bay, FL United States

Thanks, Carl.

Been wanting to install Tailgunners, but the brackets are slotted for HD, and Ma Vic is a stud. Hoping to slide a square nut into the slot on the pipe, then screw in a full threaded bolt and cut off the head to make my own studs. Not sure what size the header is though. The Tailgunners have a few sizes for their tips, and would hope to get close, or use an adapter that 'they' also sell.

Mark



Edited by witchbiker 2016-08-01 2:52 PM
Top of the page Bottom of the page
johnnyvision
Posted 2016-08-01 5:30 PM (#187943 - in reply to #186552)
Subject: Re: Exhaust header pipe


Visionary

Posts: 4278
So what does the header size have to do with the Tailgunner when it bolts into the muffler not the header
Top of the page Bottom of the page