|
|
Puddle Jumper
Posts: 16
Edmonton, Alberta,Canada | recieved cams for my vision but no instuctions,I'm wondering if this was an oversite or common practice for performance parts,have an e-mail to Lloydz but no responce yet was wondering if someone could scan a copy to me would be much appreciated. |
|
| |
|
Cruiser
Posts: 257
Under the Rule of Jedi - Masshole | I think Lloyd is in Myrtle Beach for bike week.
Best bet would be to use the service manual.
Here is a link to the manual online.
http://www.mediafire.com/2008visioninfo
Edited by Member No. 1 2009-05-15 1:50 PM
|
|
| |
|
Puddle Jumper
Posts: 16
Edmonton, Alberta,Canada | Thanx for the link but I have the manual. I just figure any tips or tricks,or actual instructions, would be very helpful. |
|
| |
|
Tourer
Posts: 354
20 miles west of Chicago. | Most dealer's will tell you that the engine has to be removed, as per the shop manual. Lloyd has said it can be done without removing the engine by prying to get the front head off. 2-4 hour job. I would wait and talk to Lloyd. I wish he would publish directions I could give to the dealer. The difference in labor/hours between having to pull the engine and not would be substantial, I think. |
|
| |
|
Tourer
Posts: 415
| I watched part of mine being done. You need to loosen the rear engine mounts and then pry it down a litle bit(I couldn't watch that part).
Don't do it without asking someone first. My guy did mine and his, with tips from Lloyd. If you cannot get any help from either Lloyd or Kevinx, let me know and I am sure I could hook you up with my dealer, he is always glad to help. |
|
| |
|
Visionary
Posts: 1340
Gainesville Fl Home of the Gators | Praxman - 2009-05-15 12:16 PM
recieved cams for my vision but no instuctions,I'm wondering if this was an oversite or common practice for performance parts,have an e-mail to Lloydz but no responce yet was wondering if someone could scan a copy to me would be much appreciated.
Don't get me wrong, but I don't ever recall getting a set of instructions with a motor part. This is not a job for the basic maint kind of people. If you do feel you are capable though then drop me a pm, and I'll give you my # to answer your questions |
|
| |
cam instructions