|
|
Puddle Jumper
Posts: 29
| How do you remove black ignition housing so I can paint console ??
thanks Craig |
|
| |
|
Iron Butt
Posts: 785
Mt. Vernon, WASH. | Looking in the Service Manual, it has two molded on hook like tabs, one one each side (3 & 9 O'clock) and the manual recommends a soft pry tool like a plastic windshield removal tool. Get gently under one side and press in S-L-O-W-L-Y to unseat one side and it should come right off. |
|
| |
|
Visionary
Posts: 1359
New Bohemia, Va | huh? remove the console and you can push the tabs together and it pops right out. You did say you were going to paint it didn't you? |
|
| |
|
Cruiser
Posts: 273
Midlothian, Va. | Do this instead. 
|
|
| |
|
Puddle Jumper
Posts: 29
| Thanks guys, Is that the carbon fiber cover ??? Looks good
Craig |
|
| |
|
Cruiser
Posts: 273
Midlothian, Va. | cag3506 - 2011-07-21 8:32 AM Thanks guys, Is that the carbon fiber cover ??? Looks good CraigYes it is by 3M. http://store.carbonfibergear.com/3m-di-noc-carbon-fiber-vinyl 12" x 48"
Edited by Biscuit 2011-07-21 7:49 AM
|
|
| |
|
Visionary
Posts: 4278
| I carbon fibered my dash and more. The trick to the key cover is turn it and the two tangs will come loose and then just wiggle it out.
Your hard part will be getting the switches back in. There a very very tight fit. You'll have to clean the square holes really good with a sharp razor. |
|
| |
Console