You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Puddle Jumper
Posts: 41
Oviedo, FL | I was attempting to install my highway pegs but the instructions were unclear to me as to how to remove the rubber floorboard insert to access the bolts to attach the pegs. I have the chrome floorboards. |
|
| |
|
Cruiser
Posts: 231
Hampton Va | They just pull up...I just did it
|
|
| |
|
Puddle Jumper
Posts: 41
Oviedo, FL | Thanks, I'll try that I just hate forcing anything. |
|
| |
|
Puddle Jumper
Posts: 22
| Don't just pull them, that could tear the insets, instead while your pulling try pinching the rubber insets from the bottom, that will cause them to pop out safely. |
|
| |
|
Tourer
Posts: 374
Tucson, AZ | Use a little soapy water and then squeeze from below as you push the tabs through.
mike v
|
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2025 Victory Riders Network™
|
|
Removing rubber floorboard insert
