|
|
Cruiser
Posts: 177
Fredonia, WI United States | Whil taking apart my Vision for "Project Stealth", I noticed a small metallic rectangle under the rear view mirror on the left side of the bike. It has a wire coming off of it, but I couldn't trace where it was going.
I put a red rectangle around it in the attached pic. What is this for? Thanks.
(IMAG0035.jpg)
Attachments
----------------
 IMAG0035.jpg (41KB - 2 downloads)
|
|
| |
|
Visionary
Posts: 3006
San Antonio, TX | I am not sure but I think it is the temperature sensor.
|
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | it's blurry so it has to be Big Foot! |
|
| |
|
Cruiser
Posts: 146
| I believe you're right on the temp sensor. Been a while but I remember asking the same question while I had mine off during the Muth Mirror Phase... |
|
| |
|
Cruiser
Posts: 177
Fredonia, WI United States | I thought the temp sensor was under the large silver panel on the front of the bike. The part you have to disconnect when you want to take the panel off.
Sorry about the blurr. It is a cell phone pic that had to be resized to the ridiculous 80 KB limit of the site.
Edited by GeekVisionRider 2010-01-17 6:08 PM
|
|
| |
|
Cruiser
Posts: 228
| The thing under the front panel is the (and I use this term very loosely), the radio antenna. |
|
| |
|
Iron Butt
Posts: 725
Reno County, KS | Was it held in by a single clip? Yep, that would most likely be the temp sensor. It should have only 1 wire running to it if you look at it from behind the speaker grill/instrument console. |
|
| |
|
Cruiser
Posts: 177
Fredonia, WI United States | Thanks for the info guys! I need to tear into my bike more often. I am learning a lot with this!
I have only had my VV since August, I guess I cant know everything yet. |
|
| |
What is this?
