You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Iron Butt
Posts: 732
Western WA | So, at some point someone, probably when I had the Kuryakyn 4710 installed, over torqued the bolts holding the upper passenger pad in place. I've never touched the thing. Although, admittedly, it does sound like something I would do.
One bolt came out fine, the other three - just spin and spin.
I've tried applying pressure behind the pad where I removed the one bolt, in the hope that the added tension would be enough to allow the bolt to start backing out but no such luck.
Suggestions? Or am I hosed into buying a new upper pad. I tried looking on the Pure Polaris site but they don't offer prices or a way to check out.
Thanks in advance. |
|
| |
|
Puddle Jumper
Posts: 18
Charleston, WV | One of the "nuts" on my pad did the same thing, I pried between the pad and the trunk top to put the "nut" in a bind and got it loose. While off of the bike I pulled it up snug with the bolt & a washer so it would reset into the back pad. Hope this helps you with yours |
|
| |
|
Iron Butt
Posts: 732
Western WA | Thanks Dean.
I'll give it another try, but I think at this point my only option is to drill/remove the bolt heads. |
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2025 Victory Riders Network™
|
|
Upper passenger pad on trunk - over torqued
