|
|
Visionary
Posts: 1290
Ruskin, Fl | Anybody running more than 4 degree advance? I was going to try a little more while the bike is apart. Just curious on people's success.
Edited by cw1115 2014-08-23 11:16 AM
|
|
| |
|
Visionary
Posts: 1340
Gainesville Fl Home of the Gators | I personally do not recommend more then 4 degrees, unless you are in the mountains
|
|
| |
|
Visionary
Posts: 1290
Ruskin, Fl | Thank you Kevin. All I need to hear. |
|
| |
|
Visionary
Posts: 1365
Central Maryland | Just another little tidbit of info regarding the timing wheel from Lloydz.... Specifically the replacement gasket. I've had the cam cover off three times now and have been able to reuse the gasket with no leakage issues. |
|
| |
|
Cruiser
Posts: 103
Davenport, IA | When I installed timing wheel, I set it to +4 degrees, pinged like crazy, then set it to +2 degrees and seems happy with this setting. |
|
| |
|
Visionary
Posts: 1365
Central Maryland | I just reinstalled my Lloydz timing wheel yesterday; after getting my bike back from the dealer to have the front drive sprocket seal replaced (had removed it and installed OEM timing wheel so preclude any warranty concerns but still got shafted with the repair bill anyway by them).
I have it set to +4 degrees at the moment; previously had reset it to +2 degrees, because "I thought" I heard some pinging at +4 as well....
I'll take it out this morning and cross my fingers. Maybe the pinging is actually the tinnitus that plagues me daily...
Edited by willtill 2014-08-24 6:38 AM
|
|
| |
|
Visionary
Posts: 4278
| Hope your running 91 octane gas |
|
| |
|
Visionary
Posts: 1365
Central Maryland | Always run premium in my Vision. From the get go.... |
|
| |
Timing
