You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Puddle Jumper
Posts: 18
Stacy,Mn | I HAVE BEEN THINKING OF DRILL AND TAP OUT THE MIRROR HOLES ON MY 08, HAS ANYONE DONE THIS OR IS THE BODY ON THE BRAKE AND CLUTCH DIFFERENT THEN ON THE 09. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | No and Yes. I started to buy the cool cup holders and was looking at the 09 on the floor and thought that should be easy. But then I realized I never saw the plugs in my mirror holes and looked at my 08, no holes.  ( I thought of drilling them out, but I'll let you do it first to see how it goes ) |
|
| |
|
Cruiser
Posts: 66
Harrisburg, PA | If you drill them on the bike your likely to drill crooked. Best bet would be to remove them place in a vice on a drill press. Or take them to a machine shop for a drill and tap... Or just buy the 09s and replace them... big $$$$$$$$$$ |
|
| |
|
Puddle Jumper
Posts: 18
Stacy,Mn | I looked up ram-mount and it uses a ¼-20 stud for there ball mount, so
I drilled both side about 20mm down and taped them out (by hand ) take your time and predrilled the holes first with a 3/32 bit and work up to tap size bit'.
I used a ¼-20-1/2" button screw instead of a plug to cover the hole till I need to use the mounts. LOOKS GOOD.
PART #
Ram-A-237U
9/16" Ball with ¼-20 stud
Edited by Del 2009-03-14 10:55 AM
|
|
| |
|
Puddle Jumper
Posts: 18
Stacy,Mn |
Model No: RAM-B-237U
This is the 1' ball, heaver duty
|
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2026 Victory Riders Network™
|
|
ORIGINAL MIRROR HOLES
