You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Tourer
Posts: 576
, IA | so where does one check the tire tread depth on metz, or avon tires or elite 3's seeing how there is no middle of the tire tread pattern on these tires<<< thanks |
|
| |
|
Cruiser
Posts: 235
Kincardine, Ontario, Canada | there are wear bars, you can see them in the grooves
Edited by candubrain 2010-04-06 7:33 PM
|
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | I thought it was when the little wires start to show... 
about every other tread there is the wear bars though, if you want to go by that. |
|
| |
|
Visionary
Posts: 1484
LaPorte,Tx. | The Dunlop E3 tires has a small Dunlop emblem molded into the tread of the tire at the outer edge of the tread. This emblem will tell you where the closest tread wear indicator is located. Also while your checking that, take a look into the bottom of the tread grove to see if there are any stress cracks. These will show up at the bottom at the edges of the tread groove. They are caused by over load and or under inflation, if they are present it is recommended to change the tire. Keeping good rubber between you and the road is very important. |
|
| |
|
Iron Butt
Posts: 741
Central New York | Huh! I thought a round tire was a good tire. 
|
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2025 Victory Riders Network™
|
|
tire tread ????
