|
|
Puddle Jumper
Posts: 14
| Have an 08 Vision Tour Premium...rolled it out of the garage today and found no resistance in the clutch lever at all. Called the dealer and they are coming to pick it up and service under warranty. Apparently there is a leak in the hydraulics somewhere although I found no fluid on the floor. Anyone experience this and what was the cause? |
|
| |
|
Tourer
Posts: 311
Atlanta Area | I would say your problem is very rare... I have not heard of anyone else having this issue... Keep us informed as to what the problem was.... |
|
| |
|
Visionary
Posts: 2300
Georgia, west of Atlanta | Sounds like maybe the seal on the plunger has a leak. That would explain no lost fluid and no pressure. |
|
| |
|
Cruiser
Posts: 156
dinwiddie, va | I replaced a slave cylinder a couple of weeks ago. thats the cylinder that does all of the work down by the primary. It was the plunger. When you squeeze the clutch, it made a noise. It is not a servicable part, and has to be replaced. They are a little bit of a pain to bleed too. So if the dealer has a time, bare with them |
|
| |
|
Visionary
Posts: 1350
| Had my slave cylinder replaced last year. I was in the bad section of New Haven, CT when it failed.  Higgin's took great care of me and my bike. |
|
| |
|
Puddle Jumper
Posts: 14
| Heard back from the dealer today...yes, it was the slave cylinder. They replaced it and should have it back Friday. Thanks for your input. |
|
| |
|
Tourer
Posts: 411
Dallas, Texas | Ok...I'll bite. I have the same '08 Vision Tour Prem...should I be worries about this slave cylinder? |
|
| |
|
Puddle Jumper
Posts: 14
| I dont know the prevalence of this problem as my inquiry was the first one on this site....I think. My '08 steel grey premium tour has around 11, 000 miles on it and other than a leaky oil pressure sensor I havent had any major mechanical issues. On the other hand, if this slave cylinder goes you're basically screwed and the bike needs to be towed. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | 66,000 and no problem there. The steering race, well now that's another story... 
Edited by varyder 2010-04-08 8:13 PM
|
|
| |
|
Visionary
Posts: 1340
Gainesville Fl Home of the Gators | rdrunner - 2010-04-08 9:06 PM
On the other hand, if this slave cylinder goes you're basically screwed and the bike needs to be towed.
.........and people think I am strange for liking cables |
|
| |
|
Tourer
Posts: 390
| I think you could get a vicegrip on the arm in a pinch.....;0 |
|
| |
|
Tourer
Posts: 390
| kevinx - 2010-04-08 8:28 PM
rdrunner - 2010-04-08 9:06 PM
On the other hand, if this slave cylinder goes you're basically screwed and the bike needs to be towed.
.........and people think I am strange for liking cables
So how do those cables work on the disc brake??  |
|
| |
No clutch Vision
