| You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network. | |
|
| |
 Clear Tail LightsJump to page : 1 Now viewing page 1 [25 messages per page] | View previous thread :: View next thread |
| Discussion -> Vision Tech Q&A | Message format |
bamavizn |
| ||
| Does any one have these or are going to purchase the Clear Tail Lights from Arizona Victory? I have a few questions about the LED's??? Read on here that LED's trick the electronics with low voltage and can cause cruise control not to work.  | |||
| |||
| Nozzledog |
| ||
| Yes, you will need to install a 25 ohm resistor between the brake wire and ground for the cruise control to work, they are fairly inexpensive and can be found at autolumination.com or on ebay for around $5. Be sure not to tap into the running lights circuit! If you are changing out the turn signal bulbs also, each will need a 6 ohm resistor between the turn circuit and ground. Autoluminations also has some very bright 10 watt LED 3157 bulbs. Stock incandescents are rated at 150/450 lumens. The 10 watt LEDs are rated at 200/600. (load_equalizer.jpg) (10wattLED.jpg) Attachments ----------------  load_equalizer.jpg (9KB - 0 downloads) 10wattLED.jpg (17KB - 0 downloads) | |||
| |||
| Jump to page : 1 Now viewing page 1 [25 messages per page] |
| Search this forum Printer friendly version E-mail a link to this thread |
| Copyright © 2007-2025 Victory Riders Network™ |