You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Visionary
Posts: 4278
| I can't show you the film cause its all most invisible on my gray vision. I did the panels just in front of the shifter and brake peg where your feet can slid up and scratch the paint.. I did the tip of the front fender and the headlight. I saw this film on youtube and a friend has it on his harley trick. The friend had a rock hit his rear fender and it damaged the film but not the paint. I gut the film from a friend who works for 3M and she said they sell a lot of it. NAPA caries it. I made templates out of computer paper cut the film and with a spray bottle of water and 30% of baby shampoo. Spared my fingers with water separated the back from the film and put it in place squeegeed out the water. http://www.youtube.com/watch?v=At5qvqz1XWI http://www.youtube.com/watch?v=At5qvqz1XWI
Edited by john frey 2011-08-22 5:28 PM
|
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | so you have to cut these to fit the vision? i had the other version of this on my 08 i would like to get some more on my 2011 vision. but the ones i had were Pre-cut. |
|
| |
|
Visionary
Posts: 1228
Rancho Cucamonga, CA | You can get precut ones from Invisigard, but it will run about $300 for the 23 cut pieces.
http://www.autotrimdesign.net/detail_IPP-VCTRY-1005__27301.html
Less if you buy thru ebay.
|
|
| |
|
Visionary
Posts: 1350
| Don't forget to put some on the edge of the fuel tank where the nozzle can damage the paint. |
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | RedRider - 2011-08-23 5:42 AM
Don't forget to put some on the edge of the fuel tank where the nozzle can damage the paint.
My 2008 vision never had this problem, but I never left the fuel pump hanging ... There is actually a warning on my2011 to Not do this... |
|
| |
|
Visionary
Posts: 3773
Pittsburgh, PA | i had the invisagard on my 2008 it was amazing. i actually heard things bounce off the front of the bike and NO chips. but honestly. out of the 23 piece kit i didnt even use half of them. i heard if you email them they will make you a custom kit, or at leat order them piece by piece. not sure how much it costs, depends on the peices you want.. |
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2024 Victory Riders Network™
|
|
3M paint Protecter
