You are currently not logged in.  Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.

Search:




VFC3 settings with Cams, intake and exhaust
Jump to page : 1 2
Now viewing page 2 [25 messages per page]		View previous thread :: View next thread
   Discussion -> Vision Tech Q&AMessage format
 
tralphaz
Posted 2010-04-11 9:54 PM (#57272 - in reply to #57194)
Subject: Re: VFC3 settings with Cams, intake and exhaust


Tourer

Posts: 353
kevinx - 2010-04-10 5:45 PM



G-3
Y-4
R-6
GB-0
YB-5.5
RB-5.5


Ding Ding Ding...We have a winner*LOL*

Tell me Kevin,
Just had had my Vision on free dyno run at a local bike rally, peak hp was 101.69 as shown on the attached dyno graph, not included on the graph was the torque which they told me was just under 110. Based on the above settings and the a/f ratio's shown on the dyno graph, what could I do in the way of settings to smooth out the a/f mixture and bring up the hp a little closer to the average of what you've seen on most Visions?




(dyno2.jpg)



Attachments
----------------
Attachments dyno2.jpg (52KB - 0 downloads)
Top of the page Bottom of the page
kevinx
Posted 2010-04-12 5:51 AM (#57284 - in reply to #56902)
Subject: Re: VFC3 settings with Cams, intake and exhaust


Visionary

Posts: 1340
Gainesville Fl Home of the Gators		You are tending towars lean in the top 1/4 of the run, and adding to the red would certainly get you a few lost HP. While most Visions are close to each other in basic mapping. Some are off one way or another. Yours just looks to one of those. Just another thought here. Looking at the speed shown; the bike was run in 4th gear, and that would reflect a good 4-5HP loss over a good run in 5th

Edited by kevinx 2010-04-12 5:54 AM
Top of the page Bottom of the page
Jump to page : 1 2
Now viewing page 2 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

Copyright © 2007-2025 Victory Riders Network™