|
|
Puddle Jumper
Posts: 5
San Francisco | Before I put back original wheel.Any suggestion what went wrong with install.
The bike won't start.
I have a 09 with ness big honkers and ness big shot.
Thanks in advance for any help
|
|
| |
|
Cruiser
Posts: 50
| Rich
Did you pinch the wires to the pick up? Did you get the wheel lined up to the key way and seated all the way on?
Does it turn over?
Did you disable the kill switch? |
|
| |
|
Puddle Jumper
Posts: 5
San Francisco | It was pinched wires.Hope it didn't kill the sensor.
Thanks |
|
| |
|
Cruiser
Posts: 50
| Rich
Glad you found it. Hope it doesn't cause you any problems. If the sensor is not shorted out and the insulation is broken make sure you keep the wires from shorting or it will fail in the future. Good luck!
Rick |
|
| |
|
Visionary
Posts: 4278
| check red switch on bars
Pinched wires on cover
pull cover look every thing over
gear should make no difference if thats all you did.
what ells did you do does the fuel pump run do you have lights |
|
| |
|
Visionary
Posts: 4278
| Did you lock tight all the bolts |
|
| |
|
Puddle Jumper
Posts: 5
San Francisco | Wires on crank sensor frayed new one on order.
Thanks for the help everyone. |
|
| |
|
Tourer
Posts: 499
Chattanooga, TN | Glad you got it sorted out, too bad about the sensor cause they can get expensive. |
|
| |
|
Visionary
Posts: 2300
Georgia, west of Atlanta | Lets us know how the re install goes. Wire looks like it goes behind the front wheel drive sprocket and along the right side of case............. |
|
| |
|
Puddle Jumper
Posts: 5
San Francisco | New sensor in and she is alive again.Took about four hours for the whole job.Was not fun getting the front sprocket cover bolts out.Did not want to remove or loosen the exhaust.
Thanks again for the advice. |
|
| |
|
Tourer
Posts: 499
Chattanooga, TN | Glad you didn't have to remove the exhaust, since that requires the right side of the fairing to be removed. Glad to hear its all good now. |
|
| |
lloydz timing won't start
