You are currently not logged in. Logon or register to access more features. Vision-Riders.com is a FREE service provided by Victory Riders Network.
|
|
|
|
Tourer
Posts: 305
Vineland, NJ United States | what is best way to remove the retaining clip for passenger floorboards. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | small, very small, flat tip screw driver |
|
| |
|
Cruiser
Posts: 206
Lumber Bridge, NC United States | replace the pins with shoulder bolts. my clips popped off during a ride and the pin was half way out when I looked at the peg getting back on the bike. the groove on the pin is to shallow to hold the clip. |
|
| |
|
Visionary
Posts: 4278
| do not re use pin it will not hold. Go to hardware with pin and ask for "C" clip |
|
| |
|
Iron Butt
Posts: 1066
Peru, IN | Too bad there's not a rear tip over withOUT the mounting boss for the rear floorboard. I NEVER have a pillion and don't like the looks of the rear boards. I took the trunk off and I think, without those, it would look more streamlined. I've thought about buying a used set of rear tip overs and cutting the mounting bosses off then repainting them. |
|
| |
Jump to page : 1
Now viewing page 1 [25 messages per page] | |
|
| Copyright © 2007-2024 Victory Riders Network™
|
|
Removing Passenger Floorboards?
